Step-by-step Guide for Buying and Installing your PDA Battery
People who own PDA’s tend to replace them often; typically they’ll only keep them for a couple of years, and then get a new one. However, this can end up being very expensive in the long run! If you want to extend the life of your PDA, or maybe you just want to replace your battery that’s been giving out lately, then keep reading. Replacing your PDA battery is a simple process but may require close attention [depending on the model].
The first step is, obviously, finding a new replacement PDA battery. The best place to find one, by far, is online. There are sites, such as pdainternalbattery.com where you can find the right battery for your PDA. You’ll be able to find great deals at places like these as opposed to local electronics stores.
If you do choose to go to a local electronic store, however, know that there’s a pretty good chance you won’t find the battery you’re looking for [all of this depends on your PDA's model and the store, however]. Going online is typically cheaper, but remember that you’ll usually have to pay for shipping and handling for your replacement PDA battery.
Once you have your battery, the next thing you need to do is check your PDA’s manual. If you threw it away or don’t have it anymore due to some other reason, then go back online. You can likely look up a manual for your PDA there. GetHighTech.com is a great place to go when you find yourself in one of these situations. Also, try to get your hands on a small Phillips head screwdriver or a Torx driver.
If your PDA has a removable panel then this will make your job much easier. All you have to do is pop it off, take out of the old battery, and put the new one in. If your PDA has a screw-off back, then just take your screwdriver and unscrew it. Some PDA batteries will be under the circuit board, however, so if you find yourself in this situation then just be sure that you handle it with care. Some batteries will be glued in, so you’ll have to pry it out with something; a butter knife or flat head screwdriver should work. If it’s held in by a clip, then just pull the clips away from it, remove the battery, and insert yours.
Some PDA batteries will be soldered to the main board. If you don’t have the tools or skills to handle this, then it’s probably a good idea to find someone who does. However, if you happen to have a soldering iron with solder, then you should be able to do it yourself. Unsolder the old battery, but pay special attention to where positive and negative are [it should be labeled]. If you get the polarity wrong, then it could spell something bad for your PDA!
Now that you’ve read this article, you should be fairly well-equipped to handle the buying and installing of your new PDA battery. This will save you tons of money in the long run, and it could end up saving you a lot of trouble, as well.
You can save a lot of money by purchasing a replacement PDA batteries from a reliable online merchant like pdainternalbattery.com, rather than the original manufacturer’s replacement.
