How to Extend the Life of Video Projector Lamps
Video projectors, unlike other electronics that can run maintenance-free, run the risk of having a much shorter lifespan if left unchecked. The lamp can explode, or just die out, much sooner than you may think. Knowing how to take care of your projector lamp is extremely useful because you won’t run as much of a risk of having to buy a $200-$600 replacement projector lamp. If you’re looking for some easy ways to extend the lifespan of video projector lamps, then keep reading for some great tips!
Handle it with care. Some people don’t treat their projector as if it were fragile, when it really is. Don’t shake it up too much, as there are highly sensitive electronics within. A projector lamp that gets bumped around a lot runs a much higher risk of dying earlier.
Be weary of the exhaust on the projector. The heat accumulated from the projector running comes out through the exhaust, and if it gets clogged or compressed in some way, the heat will build up. This will wreck your lamp in the long run if you keep letting it overheat. It’s a good idea to clean out the exhaust occasionally. Dust or other particles may get inside, and stay there, which can increase the running temperature by a lot. Also remember to not keep the video projector too close to a wall; aim for decent air circulation.
Temperature makes a big difference, too. Not just from overheating, but from the ambient temperature around the lamp itself. Some people will transport their projector in their car a lot, and as a result will leave it in their car. On hot days, this can be absolutely terrible for it, and this issue is not just confined to projectors, but for electronics in general. If you have to leave a video projector in your car, put it in the trunk where it should be significantly cooler, and/or park your car where it isn’t directly exposed to sunlight.
If your projector is cold, then this can also pose quite a risk to your projector’s lamp. If it’s too cold and you turn it on, there’s a chance that the lamp will explode. If you find that your projector is too cold, let it sit at room temperature for a while until it warms up a little. Just remember that too hot and too cold are no good; again this typically applies to all electronics.
Try not to move your projector too much right after turning it off. If you have to move it, wait until it returns to room temperature. Another tip is to not move it too much while you’re using it. Moving your projector a lot is, in general, extremely bad for it. Remember to handle it with care…
Now that you’ve read these tips of maintaining your video projector lamp, you should be able to increase its lifespan. Buying a projector replacement lamp can be extremely expensive, so it’s definitely best to take as much care of it as possible. If you’re looking for a replacement projector lamp from any of the major manufacturers you can find lots of cheap projector lamps [at unbeatable prices] through LaptopsForLess.com.
